Avtech AVC796 Manual de usuario Pagina 10

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 66
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 9
FRONT AND REAR PANELS
-6-
12) AUDIO (SLOW + ZOOM)
Press “SLOW” + “ZOOM” to select live or playback sounds of the audio channels.
Live audio of the 1st audio channel
Playback audio of the 1st audio channel
Live audio of the 2nd audio channel
Playback audio of the 2nd audio channel
Live audio of the 3rd audio channel
Playback audio of the 3rd audio channel
Live audio of the 4th audio channel
Playback audio of the 4th audio channel
The audio channel is not selected.
13) P.T.Z. ( + SEQ)
Press “ ” + “SEQ” at the same time to enter / exit the PTZ control mode.
In the PTZ control mode,
* Zoom in: Press "SEQ"
* Zoom out: Press " "
* Adjust PTZ angle: Press / / /
14) LIST (Event List Search)
To quick search the recorded files by event, press to show all types of the event lists.
15) SNAP
Press “SNAP” to take a snapshot.
Note: Before taking a snapshot, insert a compatible USB flash drive into the DVR USB port for snapshot
saving. For the compatible USB flash drive list, please refer to “APPENDIX 2 COMPATIBLE USB
FLASH DRIVE BRAND” at page 54.
16) REC (For 16CH & 8CH Models Only)
Press “REC” to start manual recording function immediately when this function is disabled.
17) EJECT (For Selected Models Only)
Press “EJECT” to open / close the DVD Writer.
18) USB
Supports firmware / OSD upgrade and file backup.
2.2 Rear Panel
1) 75Ω / HI-IMPEDANCE
When using Loop function, please switch to HI-IMPEDANCE. When you don’t use Loop function, please switch to
75Ω.
2) INPUT (1 ~ 16 / 1 ~ 8 / 1 ~ 4): Connect to video sources, such as cameras.
LOOP (1 ~ 16 / 1 ~ 8 / 1 ~ 4): Video output connector. (For Selected Models Only)
Note: The DVR will automatically detect the video system of the camera, please make sure that the
cameras are properly connected to the DVR and power-supplied before the DVR is turned on.
3) MONITOR
Connect to a CRT monitor for video output.
4) CALL (For Selected Models Only)
Connect to a call monitor.
5) Audio IN
Connect to audio sources, such as cameras equipped with the audio function.
Vista de pagina 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 65 66

Comentarios a estos manuales

Sin comentarios